Die holder DIN EN 22568 Performance
HOLD-THRDIE-EN22568-PERFORMANCE-38X14
Art.-no. 0659800500
EAN 4061975320698
Prices for customers after login
Exclusively for trade customers
Register now and access more than 125,000 products
Performance die holder in die-cast zinc for round dies in accordance with DIN EN 22568, DIN EN 24231 and factory standard. Reinforced body and black coated steel handles for high loads.
- Enables safe working with high forces due to the reinforced body and sturdy handles.
- Offers very high load-bearing capacity compared to standard models, due to an optimised tool geometry and a production process with stricter manufacturing tolerances.
- Enables easy clamping of the die by means of smooth-running locking screws with fine cross-knurling.
- Allows the dies to be clamped without a screwdriver.
- Offers high resistance due to black coated steel handles and the powder-coated die holder body.
Product information
Datasheets(X)
Instructions
- Insert the die with the slot at the level of the middle screw into the die holder.
- First, secure the middle screw with a screwdriver.
- Then tighten the 2 opposite screws to securely clamp the die.
- Then tighten the 2 remaining screws. This is how to fully secure the die.
- Position the die vertically on the workpiece.
- Use the 2 handles to apply high force when cutting.
- The HSS PERFORMANCE and HSCO MULTI PERFORMANCE dies can be used from both sides due to their 2-sided cut.
- Use sufficient lubricant when cutting.
- Turn the die back briefly after 2 turns to break the chip.
Standards | EN 22568 |
Material | Die-cast zinc |
Internal diameter x height | 38 x 14 mm |
Length | 310 mm |
Min./max. thread-cutting area, metric | 12-14 mm |
Min./Max. thread-cutting area Whitworth (W-thread), imperial | 1/2-9/16 in |